C-SCOPE CS4ZX Operating Instructions Manual page 2

CS4ZX - RAPID GET YOU GOING INSTRUCTIONS
1. Assemble and adjust for length (Twist surplus lead around stem).
2. Insert batteries.
3. Set MODE SELECT (trigger switch) to MOTION (away from your body).
4. Set DISC (top left) to ALL METAL (fully anticlockwise).
5. Set NOTCH (bottom far left) to OFF (fully anticlockwise).
6. Set SENSITIVITY (top right) to white marker (3 o'clock position).
7. METER SWITCH (centre, below meter)
a)
be in the green area on the meter.
b)
8. Push NOTCH SWITCH bottom left up to REJECT.
9. Push GROUND SWITCH bottom right up to INLAND.
You are now in ALL METAL MOTION MODE.
You will find all metals within the search head range including iron and trash PROVIDING
THE SEARCH HEAD IS MOVING OVER THE TARGET (not stationary).
To ignore these low value metals:-
10. Adjust DISC (top left) to highlight position 5.
You are now in DISCRIMINATING MOTION MODE.
The other modes require more detailed explanation acquired from reading the full
instructions.
IF A PROBLEM IS ENCOUNTERED REFER TO THE FULL INSTRUCTIONS.
2
Look for the highlighted pre-set positions
Push down and hold to indicate battery condition. Good batteries will
Push up to select METER DISC on the meter.