Table Of Contents; Safety Instructions For Two Wheel Work Stand - RIDGID AC9930 Owner's Manual

Table of Contents

Section
Table of Contents ................................2
Safety Instructions For Two Wheel
Work Stand ...................................... 2
Unpacking and Checking Contents .....4
Unpacking .........................................4
List of Loose Parts .............................4
Assembly .............................................4

Safety Instructions For Two Wheel Work Stand

Safety is a combination of common sense, staying alert and knowing how your acces-
sory works. Read this manual to understand the accessory.
Safety Signal Words
DANGER: means if the safety information
is not followed someone will be seriously
injured or killed.
Before Using the Two Wheel Work Stand
Read the following warning located on the plate assembly:
When Installing Power Tool Or Moving The Two Wheel Work Stand
Reduce the risk of dangerous environ-
ment.
• Use the work stand in a dry, indoor place
protected from rain.
• Keep work area well lighted.
• Put the work stand where neither opera-
tors nor bystanders must stand in line
with the tool's blade.
• Always get help if you need to lift the
work stand.
• When lifting, hold the work stand close
to your body. Bend your knees so you
can lift with your legs, not your back.
Never stand on work stand.
• Serious injury could occur if the stand
tips or you accidentally hit the cutting
Page Section
Operation ............................................. 6
Work Stand Set-Up ........................... 6
Work Stand Knock-Down .................. 7
Mounting Power Tools.......................... 8
Maintenance ...................................... 11
Repair Parts ...................................... 11
WARNING: means if the safety informa-
tion is not followed someone could be
seriously injured or killed.
CAUTION: means if the safety informa-
tion is not followed someone may be
injured.
tool. Do not store any items above or
near the stand where anyone might
climb on the stand to reach them.
• Maximum weight of power tool must be
100 pounds or less.
To reduce the risk of injury from unex-
pected tool movement.
• Always operate the attached tool with
the work piece moving across the direc-
tion the wheels roll.
• Check to make sure tool does not rock,
slide or move prior to use.
• Put the stand on a firm level surface
where there is plenty of room to handle
and properly support the workpiece.
2
Page