Mounting The Thickness Planer; Mounting On Legset; Mounting Thickness Planer On Supplied Legset; Mounting Thickness Planer On Other Legsets Or Work Benches - RIDGID TP1300 Owner's Manual

Mounting The Thickness Planer

Mounting on Legset

WARNING: To reduce the risk of injury from unexpected planer movement:
a. Unplug electric cord.
b. To reduce the risk of back injury, hold the tool close to your body
when lifting. Bend your knees so you can lift with your legs, not your
back. Lift by using the hand-hold areas at each side of the bottom of
the base or by the carrying handles.
c. Place the planer so other people cannot stand behind it. Thrown
debris could injure people in its path.
d. Place the planer on a firm, level surface where there is plenty of
room for handling and properly supporting the workpiece.
e. Bolt or clamp the planer to its support.
Mounting Thickness Planer on
Supplied Legset
1. Locate 4 hex screws M8 x 1.25 and the
remaining 4 flange nuts and 4 washers
in parts bag.
2. Position leg set at the desired location .
3. Mount the thickness planer as shown
with provided hardware. Only finger
tighten nuts at this time.
If necessary shift the leg set to adjust for
slightly unlevel floor. Securely tighten all
hardware.
Mounting Thickness Planer on
Other Legsets or Work Benches
Place the planer in the desired location on
either a workbench or other recom-
mended leg set. The base of the planer
has eight mounting holes. Four smaller
holes for "drywall" screws are labeled B.
Four larger holes for bolts are labeled A
(see illustration). Place a bolt through the
larger holes. Attach a washer and nut and
securely tighten.

Portable Applications

To mount the planer to a 3/4" piece of ply-
wood, use 4, 1/4" bolt holes or the 4 dry-
wall screw holes. The mounting board can
then be clamped down to prevent it from
tipping.

Work Bench Applications

Mount as specified in portable applica-
tions. Check for workpiece clearances to
front and rear of planer.
Mounting Board or Work Surface
A
B
B
15
A
B
B
A
A