R O L E O F S P E C I F I E R S A N D D E S I G N E R S
Specifiers and designers should design an automatic vehicular gate system to:
•
Utilize an operator suited for gate system type, size, frequency of use, location and
user population.
•
Separate pedestrian access from vehicle access.
•
Reduce or eliminate pinch points.
•
Reduce risk of entrapment injuries by minimizing all gaps in the gate and
enclosing the area of the travel of the gate.
•
Secure controls from unauthorized use.
•
Locate all controls out of reach from the gate.
•
Allow the user full view of the gate when operating.
•
Consider special populations, such as children or the elderly.
•
Be consistent with DASMA's Automatic Gate Opener System Safety Guide.
R O L E O F D E A L E R S , I N S T A L L E R S A N D
T R A I N E D G A T E S Y S T E M T E C H N I C I A N S
Installers, during the course of the installation proceedings for each job, should:
•
Confirm that the gate operator being installed is appropriate for the application.
•
Confirm that the gate is designed and built according to current published industry
standards.
•
Confirm that all appropriate features and accessory devices are being
incorporated, including both primary and secondary entrapment protection
devices.
•
Make sure that the gate works freely before installing the operator.
•
Repair or service worn or damaged gate hardware before installing the operator.
•
Install the gate operator according to the manufacturer's installation instructions.
•
Adjust the operator clutch or load-sensing device to the minimum force setting
that allows reliable gate operation.
•
Install operator inside fence line (DO NOT install operator on public side of fence
line).
•
Install a proper electrical ground to a gate operator.
•
Install keypad controls where users cannot touch, or reach through gate while
operating controls.
•
Install controls where user has full view of gate operation.
•
Test all features for proper functions before placing the automatic vehicular gate
into service.
•
Demonstrate the basic functions and safety features of the gate system to
owners/end users/general contractors, including how to turn off power and how to
operate the manual disconnect feature.
•
Leave safety instructions, product literature, installation manual and maintenance
manual with end user.
•
Explain to the owners the importance of a service contract that includes a routine
re-testing of the entire system including the entrapment protection devices, and
explain the need for the owners to insure that this testing is performed routinely.
•
Offer the owner/end user a maintenance contract, or contact them regularly to
offer maintenance.
2