Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Electrolux 61402 G
Summary of Contents for Electrolux 61402 G
- Page 1 61402 G 61502 G Instruction Booklet Gas Hob...
-
Page 2: Table Of Contents
Contents Important Safety Information ..................3 Instructions for the User ....................5 Description of the Hob ......................5 Operation ............................6 Maintenance and Cleaning ....................8 The Hob Top ..........................8 The Pan Supports ........................8 The Burners ..........................8 The Ignition Electrode ...................... -
Page 3: Important Safety Information
Important Safety Information You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 350350 Installation This appliance must be installed and serviced by a competent person as stated in the Gas Safety (Installation and Use) Regulations Current Editions and the IEE Wiring Regulations. - Page 4 Keep this instruction book for future reference and ensure it is passed on to any new owner. MANUFACTURER: ELECTROLUX HOME PRODUCTS ITALY S.P.A. Viale Bologna, 298 - 47100 Forlì - Italy...
-
Page 5: Instructions For The User
Description of the Hob 1. Hob Top 2. Rapid Burner 3. Semi-rapid Burner 4. Auxiliary Burner 5. Control knob for back right burner (semi-rapid) 6. Control knob for back left burner (semi-rapid) 7. Control knob for front left burner (rapid) 8. -
Page 6: Operation
Operation Hob burners control knobs The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply Lighting the burners For easier lighting, proceed before putting a pan on the pan support. To light a burner: turn the relevant knob anticlockwise to maximum position ( Upon ignition, keep the knob pushed down about 5 seconds. - Page 7 Do not keep the control knob pressed for more than 15 seconds. If the burner does not light even after 15 seconds, release the control knob, turn it the “off” position ( ) and wait for at least one minute before trying to light the burner again.
-
Page 8: Maintenance And Cleaning
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. This appliance cannot be cleaned with steam or with a steam cleaning machine. -
Page 9: Something Not Working
Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM SOLUTION There is no spark when lighting Check that the unit is plugged in the gas. and the electrical supply is switched on. -
Page 10: Instructions For The Installer
Instructions for the Installer Engineer technical data OVERALL DIMENSIONS Width: 580 mm Depth: 500 mm CUT OUT DIMENSIONS Width: 550 mm Depth: 470 mm SUPPLY CONNECTIONS Gas: R 1/2 inch (1/2 inch male) Rear right hand corner Electric: 230 V 50 Hz supply, 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse HEAT INPUT... - Page 11 BURNER RAPID SEMI-RAPID A U X I L I A R Y TYPE OF GAS POSITION M A X MIN M A X MIN M A X MIN NOMINAL THERMAL POWER 0.75 0.45 0.33 NATURAL GAS 20 mbar NOMINAL FLOW VALUE = RATE /h 0.286 0.057...
-
Page 12: Important Safety Requirements
Important Safety Requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.S. -
Page 13: Installation
Installation IMPORTANT This hob must be installed by a competent person to the relevant Gas Standards. Any gas installation must be carried out by a registered competent person. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown. -
Page 14: Gas Connection
Gas Connection Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper. The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. -
Page 15: Fitting The Hob Into The Worktop
Fitting the Hob into the Worktop Before fitting the hob into the cut out, a sealing gasket supplied with the hob must be fitted to the edge of the cut out. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below. -
Page 16: Building In
Building In Building over a cupboard or drawer If the hob is to be installed above a cupboard or ON/OFF SWITCH drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. -
Page 17: Electrical Connections
Electrical Connections Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. This hob is designed to be connected to a 230 V 50 Hz AC electrical supply. -
Page 18: Permanent Connection
Permanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations. -
Page 19: Fault Finding
Fault Finding Preliminary Electrical Systems Check Blue Brown Green Yellow START Isolate appliance Blue and carry out: Green Brown A: Earth Continuity Yellow check. Carry out: Y E S Carry out: D: Resistance to C: Polarity check. Earth check. Has inlet fuse blown? Electricity supply should now be Y E S... - Page 20 A. EARTH CONTINUITY CHECK Appliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjust zero if necessary. — Test leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 W (Ohm), check all earth wires for continuity and all contacts clean and tight.
-
Page 21: Ignition System / Gas Ignition
Ignition System / Gas Ignition Y E S Check gas supply at Ignitor does not spark burner Check plug top fuse and Light burner manually replace if necessary Check by pass simmer Check polarity and earth adjusted continuity of supply point Check fitting Check position of the Check earth continuity... -
Page 22: Commissioning
Commissioning W hen the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. 1) Turn the gas tap to the MAX position and ignite. 2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. -
Page 23: Conversion From Natural Gas To Liquid Gas
Conversion from Natural Gas to Liquid Gas IMPORTANT The replacement/conversion from natural gas to LPG should only be undertaken by a competent person. It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted. -
Page 24: Guarantee/Customer Service
Guarantee/Customer Service Standard guarantee conditions e, AEG-Electrolux, undertake that if within 12 months of the date of the purchase this AEG- Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: ·... -
Page 25: Service And Spare Parts
Customer Care For general enquiries concerning your Electrolux appliance, or for further information on Electrolux products please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.electrolux.co.uk Customer Care Department... -
Page 26: European Guarantee
European Guarantee This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move with you subject to the following qualifications: •... - Page 28 www.aeg-electrolux.co.uk...