Specifications; Safety Rules For Laser Lights - GMC CDB305MS Instruction Manual

Specifications

CDB250MS
Input power: 2000W
No load speed: 5000 RPM
Blade size: Ø250mm x
Ø16mm bore
Number of teeth: 24
Mitre table angles: 0° to 52°
left & right
Bevel cuts: 0° to 45°
left & right
Straight cut
0° x 0°: 160mm x 65mm 200mm x 80mm
Mitre cut
45° (R) x 0°: 110mm x 65mm 140mm x 80mm
52° (R) x 0°: 95mm x 65mm
45° (L) x 0°: 110mm x 65mm 140mm x 80mm
52° (L) x 0°: 95mm x 65mm
Bevel cut
0° x 45° (R): 160mm x 17mm 200mm x 22mm
0° x 45° (L): 160mm x 39mm 200mm x 43mm
Compound mitre cut
45° (R) x 45° (R): 110mm x 17mm 140mm x 22mm
52° (R) x 45° (R): 95mm x 17mm
45° (L) x 45° (L): 110mm x 39mm 140mm x 43mm
52° (L) x 45° (L): 95mm x 39mm

Safety rules for laser lights

The laser light/laser radiation used in the GMC REDEYE
CDB305MS
system is Class 2 with maximum 1mW and 400nm – 700nm
2400W
wavelengths. These lasers do not normally present an
optical hazard, although staring at the beam may cause
5000 RPM
flash blindness.
Ø305mm x
WARNING.
Ø16mm bore
A hazard may exist if you deliberately stare into the beam,
30
please observe all safety rules as follows;
• The laser shall be used and maintained in accordance
0° to 52°
with the manufacturer's instructions.
left & right
• Never aim the beam at any person or an object other
0° to 45°
than the workpiece.
left & right
• The laser beam shall not be deliberately aimed at
personnel and shall be prevented from being directed
towards the eye of a person for longer than 0.25s.
• Always ensure the laser beam is aimed at a sturdy
workpiece without reflective surfaces. i.e. wood or rough
coated surfaces are acceptable. Bright shiny reflective
sheet steel or the like is not suitable for laser use as
122mm x 80mm
the reflective surface could direct the beam back at the
operator.
• Do not change the laser light assembly with a different
122mm x 80mm
type. Repairs must be carried out by the laser
manufacturer or an authorised agent.
122mm x 22mm
CAUTION.
of procedures other than those specified herein may result
in hazardous radiation exposure.
122mm x 43mm
Please refer to the relevant Australian standards, AS 2397
and AS/NZS2211 for more information on Lasers.
4
Do not stare directly at the laser beam.
����� ������ ����� ���������
�� ��� ����� ���� �����
���� ���� ����� ���� �� ���� ����
�� �� ���� ������ ����� � ����� �������
Use of controls or adjustments or performance
®