Clean Touch Pipe -Free Spa - Operating Instructions - European Touch FORTE SPA Owner's Manual

C
LEAN
Preparing the Pedicure Spa for Operation:
After the pedicure spa is installed and the plumbing and electrical connections are made, clean and disinfect
the basin before initial use. Rinse the basin by using the attached water sprayer. Wipe the basin dry with a
clean towel.
To Operate the Pedicure Spa, Follow These Easy Steps:
Adding Water to the Pedicure Spa Basin:
1. Close the drain by turning the chrome drain handle counter-clockwise until it stops.
2. Add water to the basin by lifting upward on the water faucet fill handle. Turn the handle in a counter-
clockwise direction for cold water or clockwise for warm water as indicated by the red (hot) and blue
(cold) markings around the handle (CAUTION: hot water can burn skin). Continue to add water until the
fill line is reached. The fill line is indicated by the wavy (~~~~) line in the basin.
3. Turn the water off by pushing the handle downward and to the center.
Operating the Clean Touch
™
The Clean Touch Pipe-Free
same time delivering a soothing, quality foot massage. This unique system is driven by an impeller that pulls
water through the inlet cover and then forces the water outward. The end result is a soothing massage
delivered to all areas of the foot: front, back and bottom.
To start or stop the whirlpool, depress the On/Off button labeled "Jets" (NOTE: An indicator light on the
"Jets" button flashes when the footplate is improperly installed, or the basin contains no water. As a
result, the whirlpool will not function. To fix, simply check that the footplate is securely fastened or
add water to the basin).
Removing Water from the Pedicure Spa Basin:
First, make certain the whirlpool jets are turned off by turning the On/Off switch counter-clockwise to the "Off"
position.
If the pedicure spa is hooked up directly to a floor drain, simply open the drain by turning the drain handle in a
clockwise direction until it stops. You should see the water level lowering as water exits the basin.
If the pedicure spa is equipped with the optional Power Drain Pump (PDP) feature, open the drain by turning
the drain handle in a clockwise direction until it stops. Press the button marked "Drain" on the front panel. The
water level will lower as water is pumped out of the basin. Turn the pump off by pressing the "Drain" button on
the front panel once the basin is fully drained (NOTE: the PDP will automatically shut off after 2-1/2
minutes. We recommend turning off the pump manually if all water has drained before automatic shut-
off. Drain pump may overheat if operated more than 10 minutes in a 45 minute period).
Warning:
It is extremely important to follow the cleaning instructions located on the following page. Failure to
clean the pedicure spa adequately can result in serious health issues for your clients as well as the
nail technician. Failing to clean your pedicure spa may also cause the pedicure spa to not work
properly. Always consult your local and state codes concerning pedicure chair cleaning for further
requirements.
Document ID: 40080001
™
T P -F
OUCH IPE
™ ®
Pipe-Free System:
®
System eliminates pipes and jets that can harbor harmful bacteria while at the
Rev: F
®
S - O
REE PA PERATING
Technical Support: 800-626-6912
I
NSTRUCTIONS
Page 19 of 24