Maintenance; Troubleshooting - GMC REDEYE LSSLV Instruction Manual

Maintenance

This product has been designed to be a low-maintenance tool. However, in order
to maintain its performance, you must
ALWAYS
1. handle the tool with care. Treat it as you would any optical
device, such as a camera or binoculars.
2. AVOID exposing the self leveling vertical line generator to shock,
continuous vibration or extreme hot or cold temperatures.
3. ALWAYS store the self leveling vertical line generator indoors. When
ALWAYS
not in use, store the self leveling vertical line generator in its
protective case.
4. When you are finished using the tool,
is in "0" position.
ALWAYS
5. keep the product free of dust and liquids. Use a damp cloth and
mild soap to clean the tool. If needed,
swab and glass cleaner to clean the lens.
WARNING: ALWAYS remove the batteries when cleaning lens.
6. ALWAYS clean and thoroughly dry the tool after each use.
7. Check the batteries regularly to avoid deterioration.
the batteries from the tool, if it is not going to be used for an extended
period of time.
8. Replace the batteries after approximately 40 hours of use.
DO NOT
9. disassemble the self leveling vertical line generator.. This will not
only void the warranty, but could expose the user to hazardous radiation
exposure.
ALWAYS follow these simple directions.
ALWAYS make sure that the switch
ONLY USE
a soft cloth or cotton
ALWAYS
remove
14
10.DO NOT modify the tool in any way or use the tool with
products and/or accessories not specified in this instruction manual, this
could expose the user to hazardous laser radiation exposure.
11.DO NOT attempt to change any part of the laser lens.
NOTE: This tool is not to be tampered with and should only be repaired by
a qualified Service Technician with laser experience.

Troubleshooting

Problem Possible cause
Laser line Batteries are weak.
projection is
weak.
Laser line is Light in area is too
hard to see bright.
Batteries are weak.
Laser light is Power switch is not
not projected. "on"
Laser line The tool is not placed
projected is on a horizontal surface
not upright. or the declining angle
of it is beyond ±3°.
Solution
Replace with fresh batteries.
Use laser enhancing glasses.
Replace with fresh batteries.
Check to be sure the power
switch has been pushed
forward and is in the "1"
position.
Replace the tool on a
horizontal surface and make
sure the laser line can sway
after the tool is turned on.
15