Special Accessories - Electrolux EDC 5371 User Information

7. Unscrew cover plates E from the front of the ma-
chine, rotate through 180°, screw on the opposite
side.
8. Unscrew door lock F, push down slightly and re-
move from the front of the machine.
9. Disconnect cable connector from door lock F.
10.Press snap-in button G in and down, press cover
down slightly and remove from front of the ma-
chine.
11.Disconnect cable connector from cover G.
12.Change door lock F over to the opposite side, in-
sert the cable connector and screw down the door
interlock.
13.On the other side, insert the cable connector in
cover G, insert cover and allow snap-in button to
lock into place.
14.Insert loading door and hinges into recesses on
the front of the machine and screw down.
15.Once the door stop has been replaced, check the
function of the DOOR (TÜR) button.
Note regarding contact protection: The machine is
only secure for operations again once all plastic
parts have been inserted.

Special accessories

The following special accessories are available from
your Service Force Centre or your specialist dealer:
Intermediate installation kits for
stacked washer and dryer:
These intermediate installation kits can be used to
arrange the dryer and an automatic AEG-Electrolux
washing machine (60cm wide, front loading) as a
space-saving washer/dryer stack. The automatic
washing machine is at the bottom and the dryer is at
the top.
Two versions can be supplied:
– without stacker plate
– with extractable stacker plate
Installation kit for external conden-
sate drain
Installation kit (125 122 510) for direct draining of
condensate into a basin, siphon, gully, etc. The con-
densate tank then no longer has to be drained, it
must however remain in its intended position in the
machine. Refer to the "Programme options" section
for how to deactivate the EMPTY WATER (BEHÄL-
TER) display.
Max. displacement height: 1m from the base of the
dryer; max. displacement length: 3m
916 019 102
916 019 103
23