Troubleshooting - AEG LAVATHERM 96690IH User Manual

26 www.aeg.com/au

TROUBLESHOOTING

TROUBLESHOOTING
Problem
The tumble
dryer does
not operate.
Unsatisfac-
tory drying
results.
The door
does not
close.
(Error)
on the dis-
play.
No drum
light
Abnormally
elapsing
time on the
display.
1)
Possible cause
The tumble dryer is not connec-
ted to mains supply.
The loading door is opened.
The On/Off button was not
pushed.
The Start/Pause button was not
pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus function was in
minimum mode.
The condenser is clogged.
Load is too big
The airflow grill is clogged.
Dirt on the inner surface of the
drum.
Too high water hardness.
The filter not locked in the posi-
tion.
The laundry is locked between
the door and the seal.
You try to change the pro-
gramme or the function after
the start of the cycle.
The function you try to activate
is not applicable with the selec-
ted programme.
Defective drum light.
The time to end is calculated on
the basis of the volume and
dampness of the laundry.
)
Remedy
Connect in at mains socket.
Check fuse in fuse box.
Close the loading door.
Push the On/Off button.
Push the Start/Pause button.
Push the On/Off button.
Select applicable programme.
3)
Clean the filter.
Change the Dry Plus function to
the moderate or maximum
mode.
Clean the condenser.
Obey the maximum load vol-
ume.
Clean the airflow grill in the bot-
tom of the appliance.
Clean the inner surface of the
drum.
Set applicable water hardness
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
Turn the tumble dryer off and
on. Make the new selection.
Turn the tumble dryer off and
on. Make the new selection.
Contact the service centre to re-
place the drum light.
The automatic procedure — this
is not the appliance malfunction.
2)
3)
4)
.