Cea Specifications; Amplifier Settings; Signal Input And Output Configurations; Input Gain - Orion Cobalt CO300.2 Owner's Manual

CEA SPECIFICATIONS

CO300.2
CO600.2
HIGH LEVEL HARNESSES
Do not connect the high level input connections to power, signal, or chassis ground as damage
to the head-unit outputs may result. The high-level inputs are designed to work with either
grounded or BTL speaker level outputs (found on most head units).
Black
White/Black
White
Gray/Black
Gray

AMPLIFIER SETTINGS

The input section of the amplifier consists of a phase switch that sets the output configuration,
gain controls, and RCA inputs. The input section makes it easy to adapt this amplifier to most
system configurations.
The Orion Cobalt CO300.2 and CO600.2 amplifiers have level adjustments to allow for easy
integration with any source unit. The input sensitivity can be adjusted from 175mV to 8V. Refer
to and
instructions on setting the gain.
© 2007 directed electronics—all rights reserved
Power Output: 60 Watts RMS x 2 at 4 ohms and < 1% THD+N
Signal to Noise Ratio: -75 dBA (reference Watt into 4 ohms)
Additional Power: 80 Watts RMS x 2 at 2 ohm and < 1% THD+N
Power Output: 100 Watts RMS x 2 at 4 ohms and < 1% THD+N
Signal to Noise Ratio: -75 dBA (reference Watt into 4 ohms)
Additional Power: 155 Watts RMS x 2 at 2 ohm and < 1% THD+N
HIGH LEVEL CONNECTIONS
WIRE COLOR INPUT CONNECTION
Ground
- Left channel
+ Left channel
- Right channel
+ Right channel
sections of this guide for detailed
5