Toyota FJ Cruiser User Manual page 201

05 11.29
TS10009a
CALIBRATING THE COMPASS (circling
calibration)
Sometimes the direction display on the
compass may not change after a turn. To
rectify this, stop the vehicle and do as
follows.
1. Push and hold the "SET" button for
about 2 seconds. The zone number ap-
pears on the outside temperature dis-
play.
2. Push the "SET" button. "−−" will start
moving.
TS10010
3. Drive the vehicle in a circle at 8 km/h
(5 mph). If there is not enough space
to drive in a circle, drive around the
block.
When the compass display returns to the
outside temperature display, calibration is
complete.
When circling calibration fails, "Er" is dis-
played for 2 seconds and then "COM-
PASS" flashes. It also flashes when cir-
cling calibration is not completed.
If you want to cancel the calibration be-
fore it is complete, push the "SET" button
for about 2 seconds.
2007 FJ CRUISER from Jan. '06 Prod. (OM35857U)
Perform circling calibration just after
you have purchased your Toyota. And
then always perform circling calibration
after the battery has been removed, re-
placed or disconnected.
"
Do not perform circling calibration of
the compass in a place where the
earth's magnetic field is subject to in-
terference by artificial magnetic fields
(underground parking, under a steel
tower, between buildings, roof parking,
near a crossing, near a large vehicle,
etc.).
"
During calibration, do not operate elec-
tric systems (power windows, etc.) as
they may interfere with the calibration.
187