Emptying The Dust Cup; Cleaning The Pre-Motor Filters; Maintenance Schedule - Shark NV350 series Owner's Manual

COMPONENT
1 Dust Cup
Pre-Motor Foam Filter
2
3 Pre-Motor Felt Filter
4
Post-Motor Foam Filter
5 Post-Motor Felt Filter
6
Post-Motor HEPA Filter
Fig. 21
EMPTYING THE DUST CUP
The dust cup needs to be emptied each time you
vacuum and periodically during cleaning, when the
dust cup appears full.
1
Undo the latches on the sides of the dust cup by
lifting them up and outwards to remove the dust
cup from the motor base. (Fig. 19)
2
Hold the dust cup over a trash receptacle and press
the bottom door release button. (Fig. 20) Tap
gently to empty contents. Press the door shut
again until it clicks.
3
If needed, turn the dust cup upside down over the
trash receptacle and press the top door release
button. (Fig. 21) Tap gently to remove contents.
Use a dry cloth or paper towel to remove debris
stuck to the screen filter inside the dust cup. Press
the door shut again until it clicks.
4
Replace the dust cup on top of the motor base.
Hook the two latches onto the tabs on the sides of
the dust cup and push down to lock.
NV350_26_NV350A_26_NV350E_26_NV350T_26_NV350WM_26_IM_ENG_SPA_100929.indd 13
MAINTENANCE SCHEDULE
Empty each time you vacuum.
Rinse and air dry every 3 months under normal use.
Rinse and air dry every 3 months under normal use.
Rinse and air dry every 12 months under normal use.
Rinse and air dry every 12 months under normal use.
Clean once every 2 years or as needed.
(Model NV350E only)
Screen
Filter
Fig. 22
CLEANING THE PRE-MOTOR FILTERS
1
Remove the dust cup.
2 Pull the 2 filters out from the top of the motor
base. (Fig. 22)
3
Rinse the filters thoroughly in lukewarm water until
the water runs clear.
D O NOT put the filter in the washing machine or
dishwasher.
N OTE: The material in the filter will discolor over
time. This is NORMAL and will not affect the
performance of the filter.
4
Squeeze out excess water and let air-dry for at
least 24 hours before replacing. Do not use a hair
dryer or other heating methods to dry.
5 Place the felt filter in first, then the foam filter.
6
Replace the dust cup.
www.sharkclean.com
English
Pre-Motor
Foam Filter
Felt Filter
Post-Motor
Foam Filter
Felt Filter
HEPA Filter
(NV350E only)
13
10-09-29 11:47 AM