Brake fluid replacement
The brake fluid should be replaced only
by trained Yamaha service personnel.
Have the Yamaha dealer replace the
following components during periodic
maintenance or when they are dam-
aged or leaking:
oil seals (every two years)
brake hoses (every four years)
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU00742
1. Drive belt
2. Marks
a. Slack
Drive belt slack check
1. Put the motorcycle on the side-
stand and make sure that both
wheels are on the ground.
2. Using the reference marks at the
side of the check window, which is
located at the rear left side of the
motorcycle, note the current posi-
tion of the drive belt.
1. Belt tension gauge
3. Apply a force of 45 N (4.5 kg) with
EAU01830
4. If the measured slack exceeds
NOTE:
@
The reference marks at the side of the
drive belt check window are 5 mm
apart.
@
6-22
the belt tension gauge to the lower
drive belt run as shown and re-
check the drive belt position in the
check window. The normal drive
belt slack (i.e., the distance be-
tween the original belt position and
its position with the force applied)
is approximately 7.5 ~ 13 mm.
13 mm, adjust the drive belt.
6