Yamaha TDM900 Owner's Manual page 26

INSTRUMENT AND CONTROL FUNCTIONS
Right
1
2
3
1. Engine stop switch "
4
2. Start switch " "
5
Pass switch " "
Press this switch to flash the headlight.
6
Dimmer switch " /
7
Set this switch to "
beam and to " " for the low beam.
8
Turn signal switch "
9
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
1
2
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
/ "
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12350
Start switch "
Push this switch to crank the engine
with the starter. See page 5-1 for start-
EAU12400
"
ing instructions prior to starting the en-
" for the high
gine.
EAU12460
/ "
The engine trouble warning light and
ABS warning light (ABS model only)
will come on when the key is turned to
". When re-
"ON" and the start switch is pushed, but
this does not indicate a malfunction.
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
EAU12500
" ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
EAU12660
/ "
when your vehicle is stopped where it
" before starting
might be a traffic hazard.
" to
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
EAU12711
tery may discharge.
"
EAU44710
3-10
EAU12733
"
" posi-
ECA10061