Yamaha FJR1300 Owner's Manual page 61

1. Bolt
2. Coolant reservoir cap cover
3. Coolant reservoir cap
3. If the coolant is at or below the
minimum level mark, remove the
bolt, open the coolant reservoir
cap cover, and then open the res-
ervoir cap.
4. Add coolant or distilled water to
raise the coolant to the maximum
level mark, close the coolant res-
ervoir cap and the coolant reser-
voir cap cover, and then install the
bolt.
Coolant reservoir capacity:
0.25 L
PERIODIC MAINTENANCE AND MINOR REPAIR
CAUTION:
_
G If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
G If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be
sufficiently cooled and the cool-
ing system will not be protected
against frost and corrosion.
G If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
_
WARNING
_
Never attempt to remove the radia-
tor cap when the engine is hot.
_
6-14
EC000080
NOTE:
_
G
The radiator fan is automatically
switched on or off according to the
coolant temperature in the radia-
tor.
G
If the engine overheats, see page
6-37 for further instructions.
_
EW000067
6