Yamaha Fazer FZ6-S Owner's Manual page 47

NOTE:
The engine oil should be between the
minimum and maximum level marks.
5. If the engine oil is at or below the
minimum level mark, remove the
oil filler cap, and then add sufficient
oil of the recommended type to
raise it to the correct level.
6. Insert and tighten the engine oil
dipstick, and then install and tight-
en the oil filler cap.
To change the engine oil (with or
without oil filter cartridge replace-
ment)
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and drain bolt to drain the oil from
the crankcase.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Engine oil drain bolt
NOTE:
Skip steps 4–10 if the oil filter cartridge
is not being replaced.
4. Remove the oil filter cartridge with
an oil filter wrench.
1. Oil filter cartridge
2. Oil filter wrench
6-8
NOTE:
An oil filter wrench is available at a
Yamaha dealer.
5. Apply a thin coat of engine oil to
the O-ring of the new oil filter car-
tridge.
1. O-ring
NOTE:
Make sure that the O-ring is properly
seated.
6. Install the new oil filter cartridge
with an oil filter wrench, and then
tighten it to the specified torque
with a torque wrench.
6