Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AOpen CD-WRITER IDE5232
Summary of Contents for AOpen CD-WRITER IDE5232
- Page 1 CD-WRITER IDE5232 CD-ReWritable Drive User’s Manual...
- Page 2 C L A S S 1 L A S E R P R O D U C T A P P A R E I L A L A S E R D E C L A S S E 1 L A S E R K L A S S E 1 L U O K A N 1 L A S E R L A I T E P R O D U I T L A S E R...
- Page 3 FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation.
-
Page 4: Table Of Contents
Table of Contents INTRODUCTION YSTEM EQUIREMENTS ACKAGE ONTENTS INSTALLATION NTERFACE ONNECTIONS ARDWARE NSTALLATION RIVER NSTALLATION Windows Environment OFTWARE NSTALLATION Windows Environment CONNECTION & OPERATION RONT ANEL TECHNICAL DATA TROUBLESHOOTING... -
Page 5: Introduction
CD, a CD-R or a CD-RW. With the bundled CD-RW mastering software, CD- WRITER IDE5232 is an ideal model for creating customized audio and data CDs, and for archiving or distributing big files to achieve data interchange and backup. -
Page 6: Package Contents
CD-WRITER IDE5232 ♦ PC sufficient to run Windows 98/ME/2000/XP ♦ Pentium II 350MHz above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 200MB for installation, 1GB or more is recommended.) ♦ IDE host interface supporting ATAPI MMC command ♦... -
Page 7: Installation
CD-WRITER IDE5232 INSTALLATION Host Interface Connections Most current mainboard models have two IDE ports (primary and secondary) which can connect two IDE cables. Two IDE cables allow you to connect up to four devices, but it is recommended that you separate IDE ports for your hard drive and your CD-ReWritable drive. -
Page 8: Hardware Installation
CD-WRITER IDE5232 You may consider one of the two ways recommended below to connect your drive. ♦ To get the most stable performance for the CD-RW drive to write: Primary IDE Master: Hard Disk Primary IDE Slave: CD-ROM Drive Secondary IDE Master: CD-RW drive ♦... - Page 9 CD-WRITER IDE5232 The red-edge of the IDE Cable must be connected to Pin 1 on the CD- ReWritable drive. 5. If you have a sound card that can be connected to this CD- ReWritable drive, you can connect the drive (as Audio-out) and the sound card (as Audio-in) with a 4-pin audio cable.
-
Page 10: Driver Installation
CD-WRITER IDE5232 Driver Installation Windows Environment CD-WRITER IDE5232 device, Windows 98/ME/2000/XP can automatically detect the drive and load the appropriate driver. If Windows cannot detect the drive, you can operate manually: Click the Control Panel Icon in My Computer and then click Add New Hardware. -
Page 11: Connection & Operation
CD-WRITER IDE5232 CONNECTION & OPERATION Front Panel 1. Headphone Plug By plugging in the headphone jack here, you can listen to an audio CD (CD-DA disc) directly playing from the CD-ReWritable drive. 2. Headphone Volume Control This knob adjusts the audio output level. Turn the wheel to the right to increase the audio volume of your headphone. -
Page 12: Rear View
CD-WRITER IDE5232 5. Emergency Eject Hole When the Close/Eject button can’t work properly and the disc tray can’t be opened, you can insert a paper clip or a small rod into this hole for manual ejection. Please make sure to power off the system before you do that. - Page 13 CD-WRITER IDE5232 3. Device Configuration Jumper Set the jumper to Master, Slave or Cable Select according to your system configuration. 4. IDE Interface Connector Plug one end of the 40-pin IDE cable here to join the 40-pin IDE connector on the motherboard. The red-edge of the IDE cable must be connected to Pin 1 of each connector.
-
Page 14: Technical Data
CD-WRITER IDE5232 TECHNICAL DATA Performance Transfer rate Read: CD-ROM/CD-R: 7800kb/s (up to 52X) CD-RW: 4800 kb/s (up to 32X) Write: CD-R 7800kb/s (up to 52X) CD-RW 4800kb/s (up to 32X) Access time 90ms at ⅓ stroke(52X CD-ROM) 180ms at full stroke(52X CD-ROM) 99ms at ⅓... - Page 15 CD-WRITER IDE5232 Form factor 5.25" Half Height Disc loading Tray (motorised) Audio output level Line out = 0.6 ± 10%Vrms Headphone out = 0.6± 10%Vrms Power 5 VDC & 12VDC Dimensions Height 41.8 ± 0.2 mm Width 148.6 ± 0.3 mm Depth 193.3 ±...
- Page 16 CD-WRITER IDE5232 Environment Temperature Operating 5°C to 45°C Non-operating -20°C to 60°C Humidity Operating 8% ~ 80%RH Non-operating 5% ~ 95%RH...
-
Page 17: Troubleshooting
IDE cable, the jumper has to separate one to MASTER & the other to SLAVE. (3) If Windows can’t detect CD-WRITER IDE5232, click on the “Add New Hardware” in the Control Panel. Windows will start detecting. Q2. CD-WRITER IDE5232 doesn’t have power. - Page 18 Please insert a paper clip or small rod into the emergency hole on the front panel for manual ejection. Q8. CD-WRITER IDE5232 drive cannot write. We suggest as follows: (1) Use the burning software which is provided by original supplier and bundled with this CD-ReWritable drive or download the update file from internet.
- Page 19 Q10. Does this CD-RW drive support over-burning? Yes, but please use burning software which supports this function. Q11. Does CD-WRITER IDE5232 support CD-Text & SAO (Session At Once) function? Yes, it does support CD-Text & SAO function and you may edit the title or...
- Page 21 3100552281 Version 1.1 Feb. 2004...