Table of Contents
Advertisement
T E L E P H O N E
Handset Ringer Selection
You can select from four different handset ringer styles.
You can also turn off the ringer.
1
Make sure the handset is off.
2
Press p, #.
3
Press 1, 2, 3 or 4 to select your ringer style. You
will hear a sample of the ringer style.
4
Press o.
Turning Ringer Off
1
Press p, #.
2
Press 5.
3
Press o.
Checking Handset Ringer Selection
1
Press p, #.
2
Press 0. You will hear the current ringer style
selection.
3
Press o.
Handset Volume
Adjust the handset volume to HI or LO using the switch
on the left side of the handset.
Temporary Tone
NOTE: If you have touch tone service, you do not need
to use the Temporary Tone feature.
If you have dial pulse (rotary) service, this feature allows
you to enter codes or tones needed to operate answering
machines, or use electronic banking services, calling
cards, and other special services. This feature will operate
most special services; however, some services may
actually require a touch tone line. To be sure, ask the
company that provides the special service.
1
Dial the call, then press *. Any buttons pressed after
this send tone signals.
2
After you hang up, the phone automatically returns to
dial pulse (rotary) dialing.
O P E R A T I O N
Special Telephone Services
If you subscribe to special local telephone company
services like Call Waiting or Call Forwarding, you can
access them by pressing P whenever you would press
the switchhook on a corded phone. This is like the Flash
feature on some other phones.
Page/Handset Locator
The Page feature allows you to signal someone at the
handset from the base. You can also use this feature to
help you locate the handset.
Press G on the base. A repeating paging tone
is sounded at the handset.
Press o on the handset or G on the base to
cancel the page.
Changing Channels
If you experience interference during a call, press c to
switch to a clearer channel.
Headset Jack
You can use this telephone hands-free when you install an
optional headset and use the belt clip provided.
1
Attach the belt clip (see "Belt Clip" in the
INSTALLATION section of this manual).
2
Plug the headset (purchased separately) into the jack
located on the right side of the handset. (For best
results, use only Lucent Technologies Accessory
Headset with 2.5 mm plug.) Do not force the
connection, but make sure the plug fits securely.
3
Follow instructions under "Making a Call" or
"Answering a Call."
NOTE: The earpiece and microphone on the handset
are disabled when the headset is plugged in.
6
Advertisement
Table of Contents
