Page 12
RAISING OR LOWERING THE PRESSER FOOT 1. By raising or lowering the presser foot lifter, the presser foot goes up and down respectively. presser foot 2. For additional clearance, the foot lifter can be raised higher to fter sew on heavy fabrics. REGULATING THE PRESSER FOOT PRESSURE (Patch-O-Matic) To release the pressure, push ring (A) downwards.
Page 15
roiitlttn IrcIti • it:ttlle intl sliohilil tnlcrltic_k tiler cr0 lahrt:_ ii Ittit Tat: lilt_c Properly adjusted thread tension for straight sewing setting The needle thread is too l’hiii tight lie needle litcati ililti_li ten,iuti lucid sniting lie dial he luv.er nuniher tiers rl ate...
Page 16
STITCH LENGTH DIAL REVERSING BUTTON AND DROPPING THE FEED To change the length of the stitches proceed as follows: Turn the dial so that the number for the required stitch length is at setting mark. The numbers indicate the ap proximate stitch lengths in mm.
Page 19
WINDING THE BOBBIN 1. Release clutch by turning clutch knob toward you. through thread from spool 2. Draw bobbin winder tension disc as shown. 3. Pull end of thread through hole in bobbin as shown. winder bobbin onto bobbin 4. Place shaft with end of thread coming from the top of the bobbin.
Page 28
OVERLOCK STITCH With this seam it is possible to provide raw edges, especially on easily fraying fabrics, with a good-locking and lasting edge finish. zigzag foot Presser foot Pattern selector Stitch length dial S.S. Place the fabric under the presser foot so that the stitches are made over the edge.
Page 32
HEMMING Presser foot. hemmer foot Pattern selector Stitch length dial 1 to 4 hemmer foot Raise the foot and the needle to its highest position. Replace the foot with the hemmer foot. over the fabric edge by about 3 mm (1/8 inches) and place it Fold under the foot.