Programming Style 1 - Amana Heavy Duty Commercial Compact Owner's Manual

Programming
STYLE 1
Memory Pads
From the factory, this oven can of store up to 10
cooking programs. Follow instructions below to program
cooking times and power levels for customized cooking.
Example: Program third cooking sequence to heat for 30
seconds at 80% power.
1. Open oven door.
• Display shows "DOOR".
• If door is closed or STOP/RESET
pressed before finishing programming sequence,
oven exits programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"PROGRAM".
3. Press 3 pad to select memory pad.
• Display shows cooking time, "STAGE 1" and
power level if other than 100 percent power.
4. Press 3 and 0 pad to enter desired cooking time.
5. Press POWER LEVEL
power level.
• Display shows cooking time and current power
level if other than 100 percent power.
6. Press 8 pad to enter desired power level.
Note: Press POWER LEVEL
100% power.
7. Press START
and power level in oven memory.
• Display shows "PROGRAM".
• Repeat step 3–8 to program additional pads.
8. Press STOP/RESET
to exit programming mode.
Double Pad Programs
The oven control can be changed to store up to 100
cooking programs. See the "User's Options" section of
this manual to change oven control.
To create a double pad program, follow the instructions
above except for a change to step #3. When entering
the cooking program number, press 2 memory pads.
For example, press pads 0 and pad 3 to create a new
cooking program.
pad is
pad to change
twice to reset to
pad to save new cooking time
pad or close oven door
Multiple Cooking Stages
Follow instructions below to program oven to perform
four consecutive cooking cycles without interruption.
Example: Program third cooking sequence to heat for 30
seconds at 80% power, 40 seconds at 50% power, and
10 seconds at 100% power.
1. Open oven door.
• Display shows "READY".
• If door is closed or STOP/RESET
pressed before finishing programming sequence,
oven exits programming mode.
2. Press pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"PROGRAM".
3. Press 3 pad to select memory pad.
• Display shows "P03"briefly then cooking time,
"STAGE 1" and power level if other than 100
percent power.
4. Press 3 and 0 to enter desired cooking time.
5. Press POWER LEVEL
power level.
• Display shows "% MW POWER" and current
power level if other than 100 percent power.
6. Press 8 pad to enter desired power level.
7. press TIMe eNTrY
• Display shows cooking time, and "STAGE 2"
indicating programming stage 2 and power level
for stage shown in display.
• Repeat steps 5–8 to create additional stages.
8. Press START
and power level in oven memory.
9. press STOP/RESET
to exit programming mode.
10
pad is
pad to change
pad.
pad to save new cooking time
pad or close oven door