Ford F-150 Owner's Manual page 136

Locks and Security
Sounding a panic alarm
Press to activate the alarm. Press again or turn the ignition to
2 (ACCESSORY) or 3 (ON) to deactivate.
Note: The panic alarm will only operate when the ignition is in the
1 (OFF/LOCK) position.
Memory feature (if equipped)
The remote entry system can also control the memory feature.
Press the control once to unlock the driver's door. Pressing
the control will automatically move the seat and adjustable pedals to
the desired memory position (the memory position corresponds to the
transmitter being used).
Activating the memory feature
To activate this feature:
1. Position the seat and adjustable pedals to the positions you desire.
2. Press the SET control on the
driver's seat.
3. Within 5 five seconds, press one
control on the remote transmitter
and then press the 1 or 2 control on
the driver's door panel to which you
would like to associate with Driver 1
or Driver 2 positions.
4. Repeat this procedure for another
remote transmitter if desired.
Deactivating the memory feature
To deactivate this feature:
1. Press the SET control on the driver's door seat.
2. Within 5 five seconds, press any control on the remote transmitter
which you would like to deactivate and then press the SET control on
the driver's door panel.
3. Repeat this procedure for another remote transmitter if desired.
Replacing the battery
The remote entry transmitter uses one coin type three-volt lithium
battery CR2032 or equivalent.
136
2007 F-150 (f12)
Owners Guide (post-2002-fmt)
USA (fus)