Table of Contents
Advertisement
12
G
H
F
E
F
F
D
F
Changing the opening direction of
the doors
Before carrying out any operations, remove the plug
from the power socket.
To change the opening direction of the door,
proceed as follows:
1. Remove the ventilation grill (D);
2. Remove bottom hinge (E);
3. Slide out the lower door from middle hinge (H)
and remove the latter;
4. Slide out the upper door from pin (G), unscrew
the latter and then screw it down into the hinge
provided on the opposite side;
5. Remove the two plugs, to reveal the holes for the
hinge pivots, and remount them on the other
side;
6. Refit the upper door and the middle hinge on the
opposite side;
7. Refit the lower door and bottom hinge (E) on the
opposite side.
8. Remove the plug (F) from the ventilation grill (D)
and replace it on the opposite side.
9. Re-assemble the ventilation grill (D).
10.Unscrew the handles. Refit them on the opposite
side after having pierced the plugs with a punch.
Cover the holes left open with the plugs
contained in the documentation pack.
To line up the doors, it is possible to adjust the
middle hinge (H) horizontally by means of a tool,
after slackening the two screws (see figure).
Warning:
After having reversed the opening direction of
the doors check that all the screws are properly
tightened and that the magnetic seal adheres to
the cabinet. If the ambient temperature is cold (i.e.
in Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the
gasket or accelerate this process by heating up the
part involved with a normal hairdryer.
G
H
F
E
F
F
D
F
45
Advertisement
Table of Contents
