Memory Skip Scanning (Mr Mode); Temporary Memory Skip - Yaesu FT-2600M Operating Manual

M
When you have some continuously-active channels (like Weather broadcasts) in memo-
ries, you may wish to skip them for scanning, but still have them available for manual
selection.
To select a memory to be skipped during scanning:
(1) Recall the memory channel to be skipped. Note that Memory Channel 1 may not be
skipped, as it is the Priority Channel.
(2) Press and hold in the [MHz] key for one second, then rotate the Main Dial knob to
select "27 SKIP."
(3) Press the [MHz] key, then rotate the Main Dial knob to select "SKIP."
(4) Press and hold in the [MHz] key for one second to save the new setting and exit to
normal operation.
To re-enable a "skipped" memory channel, select "STOP" in step (3) above.
If the scanner repeatedly stops on a channel due to temporary noise or interference, you
can temporarily mark it to be skipped. The channel will be skipped until you manually stop
the scan (by pressing the PTT switch, for example).
To skip a channel temporarily, press the [MHz] key momentarily while the scanner has
stopped on the channel to be skipped. The scanner will instantaneously resume, and that
channel will not be scanned during this scanning session. Note that Memory Channel 1
may not be skipped, as it is the Priority Channel.
FT-2600M O
PERATING
S S
EMORY KIP CANNING
T
EMPORARY
M
ANUAL
(MR M
M S
EMORY KIP
Scanning
)
ODE
37