Direct Keypad Frequency Entry; B6J Microphone - Yaesu FT-2600M Operating Manual

Operation
D K F
IRECT EYPAD
The keypad of the MH-36
ating frequency. It also may be used for recall of memory channels.
To enter a frequency from the MH-36
(1) Press the [D/MR] key, if necessary, to set the transceiver into the VFO mode.
(2) While receiving on any VFO frequency, enter the digits of the desired frequency.
For example, to enter 146.520 MHz, press [1] [4] [6] [5] [2] [0].
A high-pitched "beep" will confirm each key closure as you enter the digits; the final
"beep" will be of longer duration, to confirm that the frequency entry is complete.
(3) The [#] key may be used to abbreviate the entry procedure. Pressing the [#] key sets
the current digit and all following digits to "0" to complete the entry.
For example, to enter 146.500 MHz, press [1] [4] [6] [5] [#].
To enter 144.000 MHz, press [1] [4] [4] [#].
Recalling memories is equally simple (see page 32 for details on memory operation). You
can recall a memory from the MH-36
(1) Press the Channel Number you wish to recall, then press the [*] key. For example, to
recall Memory Channel 2, press [2] [*]. To recall Channel number 135, press
[1] [3] [5] [*].
(2) To return to the VFO mode, press the front panel's [D/MR] key or the microphone's
[P] key twice (the first press recalls the H
(3) If you are in the Memory Recall mode, you can enter a new operating frequency di-
rectly, as described above for VFO operation. However, you will observe that a "T "
indicator will appear at the right side of the display; this indicates that you have switched
to the "Memory Tune" mode, which is described in detail on page 34.
18
E
REQUENCY NTRY
DTMF Microphone may be used for direct entry of the oper-
B6J
keypad:
B6J
from any operating mode: VFO, H
B6J
(MH-36 M
ICROPHONE
B6J
channel memory; see page 34).
OME
FT-2600M O
)
, or Memory.
OME
M
PERATING ANUAL