Cisco LRE CPE Hardware Installation Manual page 51

Chapter 2 Installation
Figure 2-1 Installing the Mounting Screws on Top of a Desk
Screw
Screw template
Step 4
Step 5
78-11469-04
Screw
Note The template has adhesive to hold it in place while you drill holes on the
desktop. If you have purchased a 6- or 24-multipack, you will be using the
same screw template to install each CPE. Do not use the adhesive.
Instead, hold the template against the top of the desk while you drill the
screw holes and insert the screws.
(Optional) Peel the adhesive strip off the bottom of the screw template, and attach
it to the top of the desk.
Use a 0.144-inch (3.7-millimeters) or a #27 drill bit to drill 1/2-inch
(12.7-millimeters) holes in the two screw template slots.
Cable
lock hole
Adhesive
Desktop
Cisco LRE CPE Hardware Installation Guide
Installing the CPE
Wall
3 in.
(7.6 cm)
at least
1/2 in.
(12.7 mm)
2-13