Table of Contents
Advertisement
1.7
Jumpers
This section describes and illustrates the jumpers on the motherboard.
1.
USB device wake-up (3-pin USB_PWR1 and USB_PWR2)
Set these jumpers to +5V to wake up the computer from S1 sleep
mode (CPU stopped, DRAM refreshed, system running in low power
mode) using the connected USB devices. Set to +5VSB to wake up
from S3 sleep mode (no power to CPU, DRAM in slow refresh, power
supply in reduced power mode).
The USB_PWR2 jumper is for the rear USB ports.
This feature requires a power supply that can provide at least 1A on
the +5VSB lead when these jumpers are set to +5VSB. Otherwise, the
system does not power up.
The total current consumed must NOT exceed the power supply
capability (+5VSB) whether under normal condition or in sleep mode.
P4BGL-ED
P4BGL-ED USB Device Wake Up
ASUS Prodigy P4BGL-ED Motherboard
USBPWR1
1
2
2
3
+5V
+5VSB
(Default)
USBPWR2
3
2
2
1
+5V
+5VSB
(Default)
1-9
Advertisement
Table of Contents
