Table of Contents
Advertisement
A
K
7
9
G
M
A
X
/
A
K
A
K
7
9
G
M
A
X
/
A
K
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified, continue
to the next step -
6. From the Windows 2000 Setup screen, press the Enter key. Setup will now load all device files and then continue the
Windows 2000 installation.
*********************************************************
Installing Driver in Existing Windows 2000 System
*********************************************************
WARNING: If you will be moving the boot drive containing the existing Windows 2000 operating system to the SATA150
connector, the SATA150 driver MUST be loaded on to this hard drive while it is still attached to your existing hard
drive controller. Do not attach this drive or any other hard drive to the SATA150 connector before completing this
step.
After enabling the SATA150 IDE controller and rebooting your system, Windows 2000 setup will show a "New Hardware Found"
dialog box. Under Windows 2000, "PCI Mass Storage Controller" will be displayed.
1. Choose "Search for a suitable driver for my device (Recommended)". from the list, and then press "Enter".
2. Choose "Specify a location." and then press "Next"
3. Choose "Mass Storage controller" and press "next" and next screen press "finish"
7
9
D
M
A
X
7
9
D
M
A
X
79
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
