Connecting The Appliance To The Electricity Supply; Connecting The Appliance To The Water Suppy; Permitted Water Pressure - Electrolux EW 1477 F User Manual

Connecting the appliance to the electricity
supply
Specifications relating to the mains voltage, type of
electricity and the required fuse protection can be
found on the rating plate. The rating plate is located
behind the loading door.
;
This appliance complies with the following
EU directives:
– the "Low vlotage directive"
73/23/EEC with amendments
– the "EMC Directive"
73/23/EEC with amendments
Connecting the appliance to the water
suppy
The washing machine has been fitted with
3
safety devices that prevent drinking water
from being fouled by a reflow of dirty water
and which comply with the national legal
regulations of the water boards (e.g. for Ger-
many: DVGW Directives). Additional protec-
tion measures are therefore not necessary
when installing the appliance.
Important:
– Appliances meant to be connected to the cold
water supply must not be connected to the hot
water supply!
– When connecting the appliance use only new
hose kits!

Permitted water pressure

The water pressure must be 1 bar (= 10N/cm
0,1 MPa), or a maximum of 10 bar (= 100N/cm
= 1 MPa).
• For water pressure greater than 10 bar: Use pres-
sure reduction valve.
• For water pressure less than 1 bar: Unscrew the
inflow valve from magnetic inlet valve (appliance
end) and remove the flow regulator (in order to do
this, remove the filter using needle-nosed pliers
and remove the rubber disk that is located behind
it). Replace the filter.
36
2
=
2