Electrolux EWN 820 Instruction Booklet page 16

Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the ON/OFF
button again, the washing machine will resume the
programme from the point where it had been
interrupted.
13. End of programme
The machine stops automatically.
If the RINSE HOLD has been selected, the
porthole is blocked, the light of the START/PAUSE
button goes off, the pilot lights and remain
lit, to indicate that the water must be drained.
When the programme has been completed, the pilot
light will go on again.
Press the SKIP/RESET button repeatedly to
erase the programme that has just been carried
out. If you omit to do this, the next time you
switch the washing machine on, the pilot lights
relevant to the end of the previous cycle will go
on.
Note: when you switch the machine on, if you must
erase the previously performed programme, it is
also sufficient to press the FABRIC button and
select a new programme.
Press the ON/OFF button to switch the machine
off. The relevant light will go out.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get
damaged in a subsequent wash (e.g. by shrinking)
or bleed colour into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
16