Electrolux EWN 820 Instruction Booklet page 15

7. Select the SPIN SPEED
RINSE HOLD option
Press the SPIN SPEED button
order to select the desired spin speed or the RINSE
HOLD option . The relevant light will light up.
If you select the RINSE HOLD option
machine will stop at the end of the programme with
the water still in the tub.
EWN 820
8. Select the desired options
Depress the relevant button to select the required
options. The relevant light illuminates.
9. Start the programme
Press the START/PAUSE button. The relevant light
will stop flashing and only the light relevant to the
phase that is in progress will remain lit.
or the
repeatedly, in
, the
EWN 1020
10. How to change a programme
during its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any option before the
programme carries it out.
Changing the type of fabric or temperature is
possible, obviously, only by resetting it. When you
make a change in these two parameters, the
washing machine will resume the cycle from the
beginning. The washing water in the tub will not
emptied out.
If it is necessary to drain the water in order to
change the programme in progress, proceed as
follows:
• PAUSE the machine by pressing the
START/PAUSE button;
• press the SKIP/RESET button
only the DRAIN light
• press the START/PAUSE button again.
When the water has been drained, you may select a
new programme and press the START/PAUSE
button to start it.
11. How to cancel a programme
during its cycle
To cancel a programme that is being carried out,
first pause the washing machine by pressing the
START/PAUSE button, then press the SKIP/RESET
button repeatedly, until the phase indicator lights go
out.
12. How to open the door during
a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following
conditions exist:
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the door can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by pressing the ON/OFF button.
After approximately 3 minutes, you can open the
door.
15
repeatedly, until
remains lit;