Installation; Using For The First Time - DeLonghi Coffee maker Manual

02_GB-5732131000 4-10-2004

3 INSTALLATION

• After removing the packaging, make sure the product is complete and undamaged. If in doubt, do not
use the appliance and contact a qualified professional.
• Packing elements (plastic bags, polystyrene etc) must not be left within reach of children as they may
represent a hazard.
• Place the appliance on a work surface far away from water taps, basins and sources of heat.
• After positioning the appliance on the work top, leave a space of at least 5 cm between the surfaces of
the appliance and the side and rear walls and at least 20 cm above the coffee maker.
• Never install the appliance in environments where the temperature may reach 0°C or lower (the applian-
ce may be damaged if the water freezes).
• Make sure the mains voltage corresponds to the voltage indicated on the appliance rating plate.
Connect the appliance to an efficiently earthed socket with a minimum current rating of 10A only. The
manufacturer may not be considered liable for possible incidents caused by the failure to adequately
earth the mains.
• If the power socket does not match the plug on the appliance, have the socket replaced with a suitable
type by a qualified professional.
• The power cable on this appliance must not be replaced by the user as this operation requires the use of
special tools. If the cable is damaged or requires replacing, contact an authorised service centre only to
avoid all risks.
• You should personalise water hardness as soon as possible following the instructions in paragraph 12.6.
To learn how to operate the appliance correctly, when you use it for the first time, follow the step-by-step
instructions given in the following paragraphs.

4 USING FOR THE FIRST TIME

1. The first time you use the appliance, select the language.
To set English, plug the appliance into the mains socket and wait for the appliance to display:
Press the button for at least 3 seconds until the appliance displays:
The appliance then displays the setting message in English.
2. After a few seconds, the appliance displays:
To fill, remove the tank (fig. 1), rinse and fill with fresh water. Never exceed the MAX line.
(When removing the tank, the cappuccino maker must always be positioned towards the centre of the
appliance, otherwise the tank cannot be removed).
Put the tank back and push as far as it will go.
3. The appliance now displays:
24
15:32 Pagina 24
PRESS OK TO INSTALL ENGLISH
ENGLISH I NSTALLED
FILL TANK
TURN the STEAM KNOB