InFocus LP400 User Manual page 28

U s i n g t
24
h e P r o
Rear Projection
When you turn
image so you can project from behind a translucent screen. High-
light Rear Projection, then click either mouse button to turn this
feature on and off.
Default Source
Default Source toggles between Computer and Video. This deter-
mines which source the projector checks first for active video
during power-up. Highlight Default Source and click either
mouse button to toggle between the options.
Auto Source Select
This setting toggles between On and Off. When this feature is Off,
the projector defaults to the source selected in Default Source. To
display another source, you must manually select one by press-
ing the
source
projector automatically finds the active source, checking the
default source first. Highlight Auto Source Select and click either
mouse button to turn this feature on and off.
Plug and Play
This setting toggles between On and Off. When it is On, most
new computers will automatically recognize the projector, then
set the monitor resolution and refresh rate accordingly. You need
to set the Plug and Play setting to Off for the projector to display
properly on some older computers. The Plug and Play setting
does not affect video images.
If the projector 's display constantly changes between the com-
puter image and the message, "Perfecting the image", you may
need to set Plug and Play to Off.
Display Messages
This setting toggles between On and Off. When this feature is On,
status messages such as "No signal detected" or "Standby
Active" appear in the lower-right corner of the screen. Click
either mouse button to turn this feature off and not see status
messages.
j e c t o r
Rear Projection
button on the keypad. When this feature is On, the
on, the projector reverses the