Denon AVR-1709 Owner's Manual page 67

GRemote Control UnitH
Symptom Cause
Set does not work • Batteries are worn.
properly when • You are operating outside of the
remote control specified range.
unit operated. • Obstacle between main unit and
remote control unit.
• The batteries are not inserted in
the proper direction, as indicated
by the polarity marks in the
battery compartment.
• The set's remote control sensor
is exposed to strong light (direct
sunlight, inverter type fluorescent
bulb light, etc.).
• The remote ID of the main unit
and remote control unit do not
match.
SOURCE CONTROL
• The
are not set in the correct
positions.
Countermeasure
• Replace with new batteries.
• Operate within the specified
range.
• Remove the obstacle.
• Insert the batteries in the
proper direction, following the
polarity marks in the battery
compartment.
• Move the set to a place in which
the remote control sensor will
not be exposed to strong light.
• Set "Remote ID" for the main
unit to "1" .
SOURCE CONTROL
switches • Set the
switches to the correct positions
according the operation you are
applying.
GAudioH
Page Symptom
3 No sound is • You are playing a monaural
3 produced from source (TV, AM radio broadcast,
center speaker. etc.) in the "STANDARD" (Dolby/
3 DTS Surround) mode.
No sound • The surround mode is set to
3
is produced "STEREO" or "DIRECT" .
from surround
speakers.
No sound is • The surround back speaker's
3
produced from power amplifier is assigned to a
surround back different channel.
speaker. • Surround back speaker setting is
set to "None" .
30
• The "Parameter" – "Surround
Parameter" – "SB CH OUT"
settings are "OFF" .
40, 42, 43,
47 ~ 49
• Surround mode not set to a mode
for 6.1- or 7 .1-channel playback.
No sound is • Subwoofer's power not turned
produced from on.
subwoofer. • The "Subwoofer"
"Speaker Setup" is set to "No" .
• The subwoofer is not properly
connected.
• The
turned off.
No test tones are • Surround
produced when " S TA N D A R D " ( D o l b y / D T S
main remote Surround).
control unit's
TEST
button is
pressed.
DTS sound is not • DVD player's audio output setting
output. is not set to bitstream.
• DVD player is not compatible
with DTS sound playback.
• The AVR-1709's "Input Mode"
setting is set to other than
"DTS" .
Cause Countermeasure
• The mode is set to something
other than "STANDARD" (Dolby/
DTS Surround).
• Set to a surround playback
mode.
• Check the setting and change it
as necessary.
• Set to something other than
"None" .
• Please set
"Surround Parameter" – "SB
CH OUT" to settings other than
"OFF" .
• Select a surround
mode.
• Turn on the subwoofer's power.
setting at • Set to "Yes" .
• Check the connections.
subwoofer's volume is • Adjust the subwoofer's volume
to an appropriate level.
mode not set to • Set to the "STANDARD"(Dolby/
DTS Surround) mode.
• Set the DVD player. For details,
refer to the
operating instructions.
• Use a DTS-compatible player.
• Set to the "Auto" or "DTS"
mode.
ENGLISH
Page
31
32
28
23
"Parameter" – 35
playback 31, 32
–
23
9
45
31
–
DVD player's
–
39