Fisher & Paykel E522BLE2 Installation Instructions Manual page 8

Installation instructions
US
6
CA
4. Installation
Your Fisher & Paykel Active Smart™ refrigerator is fitted with
front and rear rollers, designed for moving the product in
the forwards and backwards direction.
Avoid moving the product in a sideways direction as this
may damage the rollers or the floor covering/surface.
Your refrigerator will arrive with the front feet wound up
A
making moving the product into its final location a simple
task.
Roll the refrigerator into its final position making sure there
B
is the correct air gap between the product and surrounding
cabinetry. See minimum clearance in cabinetry dimensions
table (refer to page 5).
5. What to do if your product is unstable
Gently push the refrigerator back until the rear rollers
C
contact the floor.
Measure the gap under the front foot, which has come
■ ■
off the floor.
Obtain some solid packing material (hardwood,
■ ■
plastic, etc) which fits firmly into the gap under the foot.
Note: do not use metallic materials that may corrode,
stain and/or damage floor coverings.
Wind both front feet up and roll the product out
D
of position.
Place the packing material in the location diagonally
■ ■
opposite the front roller that lifts off the floor.
Make sure the packing material stays in place when the
■ ■
product is pushed back into position.
Ideally, the packing material is large enough to rest
■ ■
against the back wall so as to prevent it moving when
the cabinet is pushed into position.
Lower the front
of the refrigerator
Fig.1 Refrigerator feet
Unlevel floor
This foot lifts off the floor when
top front is gently pushed back
Fig 2.Unstable refrigerator
Raise the
front of the
refrigerator
Example only