Table Of Contents - Generac Power Systems 004692-2 Installation And Owner's Manual

Introduction ........................Inside Front Cover
Read This Manual Thoroughly ........................IFC
Contents ..........................................................IFC
Operation and Maintenance ............................IFC
How to Obtain Service ....................................IFC
Authorized Dealer Locator Number ................IFC
Safety Rules ........................................................2
Standards Index ..................................................3
Section 1 - General Information ..................4
1.1 Unpacking/Inspection ....................................4
1.2 Protection Systems ........................................4
1.3 NEC Requirement for Arc Fault Circuit
Interruption Breaker for Bedrooms ..............4
1.3.1 Section 210.12 Arc Fault Circuit
Interrupter Protection ........................4
1.4 The Generator ..............................................5
1.5 Specifications ................................................6
1.5.1 Generator ..........................................6
1.5.2 Engine ................................................6
1.6 System Set LED ............................................7
1.7 Fuel Requirements and Recommendations....7
1.8 Fuel Consumption ........................................7
1.9 Reconfiguring the Fuel System ......................7
1.10 Location ........................................................8
1.10.1 Generator ..........................................8
1.10.2 Transfer Switch ..................................8
1.11 Battery Installation ........................................8
1.12 The Battery....................................................9
Section 2 - Post Installation Start-up
and Adjustments ......................10
2.1 Before Initial Startup ..................................10
2.2 Check Transfer Switch Operation................10
2.3 Electrical Checks ........................................10
2.4 Generator Tests Under Load ......................11
2.5 Checking Automatic Operation ....................11
2.6 Adjusting the Regulator
(Natural Gas Only)........................................11
2.7 Engine Governor Adjustment ......................12
2.7.1 Additional Corrosion Protection ......13
2.8 Voltage Regulator Adjustment ......................13
Section 3 - Operation ....................................13
3.1 Break-in Procedure......................................13
3.2 Using the AUTO/OFF/MANUAL Switch ........13
3.2.1 "Auto" Position ..................................13

Table of Contents

Air-cooled 8.5 kW Generator
3.2.2 "Off" Position ....................................14
3.2.3 "Manual" Position ............................14
3.3 Automatic Transfer Operation ....................14
3.4 Sequence of Automatic Operation................14
3.5 Manual Transfer Operation ........................14
3.5.1 Transfer to Generator
Power Source......................................14
3.5.2 Transfer Back to Utility
Power Source......................................15
3.6 Setting the Exercise Timer ..........................15
3.7 Protection Systems ......................................16
3.7.1 Low Oil Pressure Switch ..................16
3.7.2 High Temperature Switch ................16
3.7.3 Overcrank ........................................16
3.7.4 Overspeed ........................................16
Section 4 - Maintenance ..............................16
4.1 Fuse ............................................................16
4.2 Checking the Engine Oil Level ....................16
4.3 Changing the Engine Oil ..............................17
4.3.1 Engine Oil Recommendations ..........17
4.3.2 Oil Change Procedure ......................17
4.4 Changing the Oil Filter ................................17
4.5 Changing the Engine Air Cleaner ................17
4.5.1 8.5kW Generators ............................17
4.6 Spark Plug(s) ..............................................18
4.7 Battery Maintenance ....................................18
4.8 Adjusting Valve Clearance ............................19
4.9 Cooling System ............................................19
4.10 Attention After Submersion ........................20
4.11 Out of Service Procedure ............................20
4.11.1 Removal From Service ......................20
4.11.2 Return to Service..............................20
4.12 Corrosion Protection ..................................20
4.13 Service Schedule ........................................21
Section 5 - Troubleshooting ........................22
5.1 Troubleshooting Guide ................................22
Section 6 - Mounting Dimensions..............23
Section 7 - Electrical Data ............................24
Section 8 - Exploded Views and
Parts Lists....................................32
Section 9 - Notes ............................................46
Section 10 - Warranty ....................................48
Generac ® Power Systems, Inc. 1