Adjusting The Thermostat - DeLonghi HCA Instructions Manual

Your convector is now wall mounted.
The appliances should not be installed directly under a wall power
socket.
Do not use your heater in a bathroom.
The appliance should not be installed immediately below a
permanent mains outlet.
Position the appliance so that the plug and the outlet can
be easily reached even after installation.
4. How to use it
This heater has ECC (electronic climate control) which automati-
cally monitors and selects the ideal power to maintain a chosen
temperature.
Insert the plug into the mains socket and switch on, pressing the
button (fig. 2) one or more times, to select your operating heating
power as follows:
The LEDs on the left hand side show you the power selected (fig.2)
The LEDs on the right hand side show you the actual power the
heater is operating at. (fig.3)
Important: when the heater has been set for timed operation and
is in a standby period (i.e waiting to come on), the LEDs on the
right hand side will light up and go out intermittently. (See timer
instructions).

5. Adjusting the thermostat

If maximum power has been selected, adjust the thermostat dial
(fig. 4) to the desired comfort temperature from
MAX (35°C).
If the selected temperature is higher than the actual room temper-
ature, the appliance will start automatically and rapidly heat the
room until it reaches the selected temperature. The unit will auto-
matically maintain the temperature at a constant level by cycling
between max power, med power and min power as it approaches
the selected comfort temperature (see fig. 5).
6. Maximum power example (fig.5)
Display LEDs
Selected Power
Power used
MAX
Electric Heating Convector HCA
*
(5°C) and
MAX
MED MIN OFF
Cycles between
4
Fig.2
A
Press once
Maximum power
B Press twice
Medium power
C
Press three times
Minimum power
D
Press four times
OFF
Fig.3
Fig.4