Starting A Washing Programme - Electrolux ESL4143 Use & Care Manual

Table of Contents

Advertisement

Starting a Washing Programme

In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off button
All the indicator lights of the programme selection buttons
illuminate.
4. Setting and starting the programme
To select a programme, press the programme button of
the washing programme you wish to select (see "Washing
Programmes" chart).
The corresponding indicator light remains illuminated
while the other programme buttons indicator lights turn off.
Close the dishwasher door, the programme will start
automatically.
Setting and starting the programme with
delay start
Press the button corresponding to the required
programme (see "Washing programmes" chart).
Press the Delay button until the indicator light
corresponding to the chosen hours flashes (3h, 6h or 9h).
Close the dishwasher door, the countdown starts
automatically and will decrease with steps of 3 hours.
The opening of the door will not modify or interrupt the
countdown.
Once the delay start has elapsed the programme will
start automatically.
NOTE:
the start of the programme or the countdown of
the delay start will occur only after the closure of the
dishwasher door, until this moment it is possible modify the
set made.
NOTE:
Once the washing programme has started, a
point-shaped optical signal appears on the floor beneath
the dishwasher's door. This optical signal will remain
illuminated for all the duration of the washing programme.
If the appliance has been installed higher up with a
furniture door mounted flush, the optical signal will be no
longer visible.
5. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it's absolutely necessary
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
Interrupt a washing programme in progress
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point at
which it was interrupted.
Cancel a washing programme in progress
Open the dishwasher door.
Press simultaneously function buttons 2 and 3 for about 2
seconds, the indicator light of the button corresponding to
the running programme starts flashing.
After about 2 seconds the indicator lights of all the
programme buttons will illuminate indicating that the
running programme has been cancelled and that the
machine has returned to setting mode.
If a new washing programme is selected, check that there
is detergent in the detergent dispenser.
6. Cancelling the delay start in
progress
Open the dishwasher door and press the Delay button
until the indicator lights corresponding to the delay start
hours (3h, 6h or 9h) turn off.
In this case the selected washing programme will start
automatically after the closure of the door.
7. End of the washing programme
The dishwasher will automatically stop and an audible
signal informs you of the end of the washing programme.
When the washing programme has ended, the optical
signal on the floor beneath the dishwasher's door will turn
off. Open the dishwasher door only when this optical
signal turns off.
Open the dishwasher's door, leave it ajar and wait a few
minutes before removing the dishes; in this way they will
be cooler and the drying will be improved.
The End indicator light is illuminated.
Switch off the dishwasher by pressing the On/Off button.
8. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
12

Advertisement

Table of Contents
loading

Table of Contents