Door Reversal - Electrolux EU7119C Instruction Book

Door Reversal

1. Close the cabinet and pull out the plug from the
electrical outlet.
2. Remove the ventilation grille. There is a part on
the grille that can be removed. Remove it and put it
on the other side.
3. Put the cabinet on a wooden board when it is laid
down. Later, when raising the cabinet, it will be
easier to grip under the cabinet thanks to the board.
4. On the upper part of the cabinet. Put the hinge pin
on the other side.
5. On the lower part of the cabinet.
a Unscrew the hinge.
b Remove the door-closing fittings from the hinge
and put the hinge pin on the other side. Then attach
the supplied door-closing fitting.
6. a. Remove the door-closing fitting from the
bottom of the door.
b. Remove the plastic plug from the corresponding
hole on the other side. Use a screwdriver to rock the
plug loose. Then secure the supplied door-closing
fitting.
c. Secure the lower hinge.
7. Raise the cabinet and replace the ventilation grille.
8. Unscrew the handle. Carefully press in the plastic
plugs on the opposite side using a drift. Secure the
handle in the plug holes. Then press the supplied
plastic plugs into the holes to which the handle was
previously fitted.
Different models
8. To transfer the handle.
Unscrew the screws. Fit the handle onto the opposite
side by turning it one half circle.
9. Put the cabinet in position. Check that it stands
straight. See the section "Positioning the cabinet".
1
2
3
4
5.a
8
8
14
5.b
a
b
c
Electrolux 818 16 17-03/9