Table of Contents
Advertisement
12 electrolux use
"E E n n d d o o f f p p r r o o g g r r a a m m m m e e " " l l i i g g h h t t
This light is on at the end of the cooling
phase, during the anti-creasing phase and at
the end of the programme.
"W W a a t t e e r r r r e e s s e e r r v v o o i i r r f f u u l l l l " " " l l i i g g h h t t
This light indicates that the appliance is in the
drying phase. .
This light comes on at the end of the
programme to remind you that the water
reservoir must be emptied out. If this light
illuminates during a programme this means
that the water reservoir is full. The buzzer
sounds, the programme stops, the light of
the Start/Pause button flashes. This light
comes on also when the water reservoir is
not inserted correctly.
" " F F i i l l t t e e r r c c l l e e a a n n i i n n g g " " l l i i g g h h t t
This light illuminates at the end of the
programme to remind you that the
filters must be cleaned.
" " C C o o n n d d e e n n s s e e r r c c l l e e a a n n i i n n g g " " l l i i g g h h t t
It comes on every 80 cycles to remind you
that the condenser must be cleaned.
Cancelling a programme
Turn the selector dial to "O" to cancel
a programme which is running. Now
you can select a new programme.
At the end of the programme
If the laundry is not removed at the end
of the cycle, the dryer performs an a a n n t t i i - -
c c r r e e a a s s i i n n g g phase (duration: 30 minutes
maximum).
If you do not remove the laundry, the
dryer will stop automatically at the
end of the anti-creasing phase.
Lights End/Anticrease,
remain lit and the buzzer sounds for
2 minutes.
Turn the programme selector dial to " " O O " "
to switch the machine off. Remove the
laundry from the drum and carefully
check that the drum is empty.
If you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
Turn the programme selector dial to "O O ";
A A f f t t e e r r e e a a c c h h u u s s e e
• Clean the filters.
• Empty the water reservoir.
I I m m p p o o r r t t a a n n t t ! !
If the drying programme has to be
stopped before it reaches the end, we
recommend that you turn the pro-
gramme selector dial to position Cooling
phase before removing the laundry. This
will avoid a build-up of heat inside the
appliance.To do this first turn the dial to
"O O " and then to Cooling
depress Start button.
M M o o d d i i f f y y i i n n g g t t h h e e p p r r o o g g r r a a m m m m e e
To change a programme which is run-
ning, first cancel it by turning the pro-
gramme selector dial to "O O ". Select the
new programme and press the Start
button .
and
all the lights go out. The appliance is
switched off.
Remove the laundry.
I I f f y y o o u u o o p p e e n n a a n n d d t t h h e e n n c c l l o o s s e e t t h h e e d d o o o o r r
b b e e f f o o r r e e t t u u r r n n i i n n g g t t h h e e s s e e l l e e c c t t o o r r d d i i a a l l t t o o " " O O " "
a a l l l l t t h h e e l l i i g g h h t t s s c c o o r r r r e e s s p p o o n n d d i i n n g g t t o o t t h h e e
p p h h a a s s e e s s m m a a k k i i n n g g u u p p t t h h e e p p e e r r f f o o r r m m e e d d
p p r r o o g g r r a a m m m m e e c c o o m m e e o o n n . .
and wait until the end of this cooling
and
Advertisement
Table of Contents
