When The Refrigerator Is Not In Use; Trouble Shooting; How To Change The Bulb; If Something Does Not Work - Electrolux ERB 8643 Instruction Book

When the refrigerator
is not in use
In case the appliance will not be used for a long time follow
these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Press the rear hook (1) and at the same time slide the cover
in the direction indicated by the arrow (2). So the bulb can
be replaced. (Bulb type: T 25 230-240 V,
thread)
After changing the bulb replace the cover, snap it in place
and apply voltage to the appliance.

If something does not work

During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information is
given about them to avoid unnecessary charges on service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, this goes together with the operation of
the appliance.
We draw it to your attention again that the appliance
operates discontinuously, so the stopping of
compressor does not mean being no-current. That is why
you must not touch the electrical parts of the appliance
before breaking the circuit.
25 W, E 14
GB
65