Abit KV7-V User Manual page 48

3-22
Back to PnP/PCI Configurations Setup Menu:
PCI/VGA Palette Snoop:
This item determines whether the MPEG ISA/VESA VGA cards can work with PCI/VGA or not.
[Enabled]: MPEG ISA/VESA VGA cards work with PCI/VGA.
[Disabled]: MPEG ISA/VESA VGA cards do not work with PCI/VGA.
Allocate IRQ To Video:
This item assigns an IRQ for the VGA card installed.
[Enabled]: Automatically assign an IRQ for the VGA card installed.
[Disabled]: The IRQ that was previously occupied by the VGA card will be available for new device.
Allocate IRQ To USB:
This item assigns an IRQ for the USB device connected.
[Enabled]: Automatically assign an IRQ for the USB device connected.
[Disabled]: The IRQ that was previously occupied by the USB device connected will be available for
new device.
PIRQ_0 Use IRQ No. ~ PIRQ_3 Use IRQ No.:
This item specifies the IRQ number manually or automatically for the devices installed on PCI slots.
For the relations between the hardware layout of PIRQ (the signals from the VIA VT8237 chipset), INT#
(means PCI slot IRQ signals) and devices, please refer to the table below:
Signals
PIRQ_0 Assignment
PIRQ_1 Assignment
PIRQ_2 Assignment
PIRQ_3 Assignment
NOTE:
•
PCI slot 1 shares IRQ signals with AGP slot, LAN, and SATA.
•
PCI slot 4 shares IRQ signals with PCI slot 5.
•
If you want to install two PCI cards into those PCI slots that share IRQ with one another at the same
time, you must make sure that your OS and PCI devices' driver supports the IRQ sharing function.
KV7 Series
AGP LAN PCI-1
INT A INT A INT A INT D INT C INT B INT D INT A
INT B INT B INT A INT D INT C INT C
INT C INT B INT A INT D INT B
INT D INT C INT B INT A INT A
PCI-2 PCI-3 PCI-4
Chapter 3
PCI-5 SATA