Abit KV7-V User Manual page 37

BIOS Setup
it to 2T Command for system compatibility or to 1T Command for system performance.
Write Recovery Time:
Two options are available: 2T or 3T. The default setting is 3T. This is the period between two write times.
DDR400 tWTR timing control
Two options are available: 1T or 2T. The default setting is 2T. This is the Internal WRITE to READ
command delay time period.
DDR DQS Input Delay:
Two options are available: Auto or Manual. The default setting is Auto. If you set to Manual, then the
next item will be available.
Input Delay Value:
This item allows you to adjust the data input strobe delay time of memory. You can key in the HEX
number into this section.
DDR DQS Output Delay:
Two options are available: Auto or Manual. The default setting is Auto. If you set to Manual, then the
next item will be available.
Output Delay Value:
This item allows you to adjust the data output strobe delay time of memory. You can key in the HEX
number into this section.
Back to Advanced Chipset Features Setup Menu:
AGP & P2P Bridge Control:
Click <Enter> key to enter its submenu:
CPU to AGP Post Write:
Leave this item to its default setting.
3-11
User's Manual