NEC DT330 User Manual page 23

1.
BUSY
BUSY
(1)
4:26 PM
MIC CB
Push >>>
BUSY
(2)
4:26 PM
S&R
CONNECTION
4:26 PM
MIC DND
CONSULTATION HOLD
TRANSFER
4:26 PM
MIC CONF
Soft Key Features
When the Soft Key corresponding to a desired feature
name is operated, the selected feature name starts to
blink on the LCD. The blinking display of available
features takes precedence over the display of features
specified by the Soft Key pattern.
Note: The Soft Keys can be programmed in System
Data to blink, remain steady, have no indication,
or display a character when either in use or idle.
2000
TUE 13 APR 2004
CW >>>
2000
TUE 13 APR 2004
>>>
2000
TUE 13 APR 2004
>>>
2000
TUE 13 APR 2004
>>>
The following shows the default display patterns of
main features.
FDB (Call Forwarding - Busy Line)
Permits a call to a busy station to be immediately
forwarded to a predesignated station.
FDA (Call Forwarding - All Calls)
Permits all calls designated for a particular station to be
routed to another station regardless of the busy or idle
status of the called station.
FDL (Logged Out IP Station - Call Destination)
Enables a system to transfer the call to appropriate
station when Dterm whose LOGGED OUT IP STATION
- CALL DESTINPLATION has already been registered
is in logout status.
E-OVR (Executive Override)
Enables selected station users, upon encountering a
busy condition at an internal station, to bridge into the
busy connection.
CW (Call Waiting)
Enables a busy station to receive a second incoming
call. A camp-on indication tone is sent to the busy
station, and the user can use a switchhook flash to
answer the second call.
CB (Call Back)
Provides the ability for a calling station to set a CALL
BACK. The calling station will be rung as soon as the
busy station becomes available.
S&R (Save and Repeat)
Allows a station to save a specific dialed number and
then redial that number later.
16