Water Tank Cleaning; Cooling Compartment Cleaning; Water Dispenser Maintenance - Sunbeam 101 User Manual

WATER DISPENSER MAINTENANCE

WATER TANK CLEANING INSTRUCTIONS
1) Do not flick the power switches quickly on and off. The resulting power surges may
damage your water dispenser.
2) Always turn your water dispenser off when there is no water left in the bottle
or when you are changing bottles. Turn it back on after the new bottle has
been placed and the air is purged from the dispensing buttons.
3) To clean the unit, first unplug the power cord. Wipe the outside of the water dispenser
with a soft cloth dampened with liquid dishwashing soap. Use toothpaste to remove spots
on the cabinet.
4) Twist the bottle receptacle of the No-Spill system counterclockwise and pull it up (Fig. A ) .
5) Take apart the No-Spill system by unscrewing the base (piercing pin) (Fig. B). Then proceed
to wash it with dishwa s h i n g liquid, rinse it and reassemble.
6) Clean the inside of the water dispenser periodically with a small amount of vinegar. This
removes mineral scaling caused by the water. Rinse it well. Use the drain on the back in
order to get the water out. Make sure to open up all the taps to ensure that all cleaning
liquid is drained from your water dispenser. Put all of the parts back, securely fasten the
drain plug (Fig. C). It is important to let the water dispenser dry for TWO HOURS before
plugging it back in. Cover the bottle receptacle to prevent it from contamination.
7) The harder the water you use, the more often you should clean the interior of the unit.
Recommended intervals are between one and three months depending on the mineral
content of the water and the frequency of bottle changes.
COOLING COMPA RTMENT
CLEANING INSTRUCTIONS
1) To clean the unit, first unplug the power cord.
2) Allow the ice build-up to melt naturally.
NOTE: Do not use sharp objects or knives to remove ice buildup.
Do not use boiling water to remove ice.
3) The water will accumulate in the tray at the bottom of the compartment.
4) Remove the tray from the compartment and empty the water.
5) Wipe the compartment and the tray with a soft cloth dampened with liquid
dishwashing soap.
A
Tw i s t
B
C
D ra i n
- 5 -
No. 0101
L i f t
Piercing Pin