Table of Contents
Advertisement
Table 6-6. Linux Operating System Error (continued)
Error Message
smartd[smartd[2338]
Device: /dev/sda, Bad
IEC (SMART) mode
page, err=-5, skip
device
smartd[2338] Unable
to register SCSI
device /dev/sda at
line 1 of file
/etc/smartd.conf
LED Behavior Patterns
The external SAS ports on the PERC 5/E Adapter have a port status LED per x4 SAS port. This bi-color
LED displays the status of any external SAS port. The LED indicates whether all links are functional or
only partial links are functional. Table 6-7 describes the patterns for the port status.
Table 6-7. LED Behavior Patterns
Port State
Power-on state
Reset state
All links in port connected
One or more links are not connected (applicable only in wide port configurations) Amber light on
All links in the port are disconnected or the cable is disconnected
Audible Alarm Warnings
An audible alarm is available on the PERC 5/E Adapter to alert you of key critical and warning events
involving the virtual disk or physical disk problems. You can use the Basic Input/Output System (BIOS)
Configuration Utility to enable, disable, or silence the on-board alarm tone.
NOTE:
Silencing the alarm stops only the current alarm, but future alarms will be sounded. To permanently disable
the alarm, select the disable alarm option.
Suggested Solution
These error messages are caused by an unsupported command coming directly
from the user application. This is a known issue in which user applications try to
direct Command Descriptor Blocks to RAID volumes. This error message has no
effect on the user and there is no loss of functionality due to this error.
The Mode Sense/Select command is supported by firmware on the PERC 5.
However, the Linux kernel daemon is issuing the command to the virtual disk
instead of to the driver IOCTL node. This action is not supported.
LED State
Off
Off
Green light on
Off
Troubleshooting
79
Advertisement
Table of Contents
