Table of Contents
Advertisement
Setting up
Adjusting adjustable feet
In order to make the projection screen rectangle, place the projector on a flat surface with its front surface parallel
to the screen. If the screen is tilted lower, extend the adjustable feet and adjust the angle to make a rectangle
screen. If the projector is tilted horizontally, also use the adjustable feet and adjust the angle to keep the projector
flat. The adjustable feet can be extended by turning it as shown in the figure, and it is retracted by turning it in the
reverse direction.
Attention
z Heated air is expelled from the air exhaust port. Do not touch the air exhaust port directly when adjusting the
adjustable feet. (
Note
z Tighten the adjustable feet until you hear them click into place.
Lens shift and positioning
If the projector is not positioned right in front of the center of the screen, you can adjust the projected image
position using the lens shift function.
■ Adjusting the lens shift
▶
1) Remove the lens shift cover.
▶
z Refer to "Removing the lens shift cover" (
2) Rotate the lens shift lever counterclockwise to release the lock.
26 - ENGLISH
page 20)
page 20) for how to remove the lens shift cover.
Adjustable range
Adjustable feet: 16 mm (5/8")
Advertisement
Table of Contents
