Voice Mail Test; Loopback Test; Speakerphone Test (With Voice Option) - Multitech MT9234ZPX-UPCI User Manual

Voice Mail Test

modem's voice function:
To test the
1. Set up the MultiModem for voice mail.
2. Use another phone to call and leave a message and then play it back.
If your modem does not play sound files in voice mode:
1. Open the Windows Control Panel and double-click the MultiModem icon.
2. Click Audio tab, select Modem Wave Driver as your preferred device for both playback and recording.
3. Repeat the voice mail test.

Loopback Test

1. Connect a microphone and speaker to the modem. To avoid feedback, separate the microphone and speaker
or use a headphone instead of a speaker.
2. Select Start, point to Programs, point to Accessories, and click HyperTerminal.
3. Click Cancel in the Connection Description dialog box.
4. In the HyperTerminal terminal window, type AT&&S and press Enter. This command causes input from the
microphone to be looped back to the speaker.
5. Speak into the microphone. You should hear your voice on the speaker or headphone.
6. Type ATZ and press Enter to reset the modem.

Speakerphone Test (with voice option)

1. Connect a microphone and speaker to the MultiModem.
2. Select Start, point to Programs, point to Accessories, and click HyperTerminal.
3. Click Cancel in the Connection Description dialog box.
4. In the HyperTerminal terminal window, type
AT+FCLASS=8
AT+VLS=7
ATDTxxxxxxx (for xxxxxxx substitute a telephone number)
5. Speak into the microphone to talk to the person on the other end of the line, and listen over the speaker.
6. Type +++ATH and press Enter to hang up.
7. Type ATZ and press Enter to reset the modem.
MultiModem ZPX UPCI/PCIe User Guide
Appendix A - Troubleshooting
23