American DJ SWEEPER BEAM QUAD LED User Instructions page 7

Sweeper Beam Quad LED
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to keep the LED display on at
all times, or "OFF" to switch to have the LED display switch off
after 10 seconds. To make the display reappear, press and hold
the MENU button for at least 5 secs.
3. Press ENTER to confirm. To make the display reappear, press
and hold the MENU button for at least 5 secs.
DISP
- This will "flip" the LED display 180º.
1. Press the MENU button until "DISP" is displayed, press
ENTER.
2. Either "DISP" or "DSIP" will now be displayed. Press the
ENTER button to "flip" the display.
TILT -
This function activates tilt inversion.
1. Press the MENU button until "TILT" is displayed, press
ENTER.
2. The display will show either "YES" or "NO". Press the UP
or DOWN buttons to select "YES" to activate tilt inversion, or
"NO" to deactivate tilt inversion.
3. Press ENTER, and then press and hold the MENU button for
at least 3 seconds to activate.
REV -
This function is used in conjuction with DMX
mode. The direction in which the projector lenses/LEDs
light up can be reversed so that the LED line up can start at
either end of the bar. This feature is useful when the unit is
installed in a reversed orientation so the unit itself does not
have to be uninstalled and reversed.
ADJ Products, LLC - www.adj.com - Sweeper Beam Quad LED User Manual Page 13
System Menu Sweeper Beam Quad LED
Example: When using 35 Channel mode (LED 1) can start at
either end of the bar depending on this functions set up.
1. Press the MENU button until "REV" is displayed, press
ENTER.
2. The display will show either "YES" or "NO". Press the UP or
DOWN buttons to select "YES" which will have the projector
lenses/LEDs light up right to left, or "NO" which will have the
projector lenses/LEDs light up left to right.
3. Press ENTER to confirm.
TEST
1. Press the MENU button until "TEST" is displayed, press
ENTER.
2. The fixture will now run a self test.
TEMP
temperature of the unit.
1. Press the MENU button until "TEMP" is displayed, press
ENTER.
2. The current temperature of the fixture will now be displayed.
Press MENU to exit.
FHRS
time of the fixture.
1. Press the MENU button until "FHRS" is displayed, press
ENTER.
2. The running time of the fixture will now be displayed. Press
MENU to exit.
ADJ Products, LLC - www.adj.com - Sweeper Beam Quad LED User Manual Page 14
- This function will run a self test program.
- With this function you can check the current
- With this function you can display the running
System Menu