Miele KM 362 G Operating Instructions Manual page 16

The control knobs are used to switch on
the burner and regulate the strength of
the flame.
&
ß the gas supply is turned off
& strong flame
/ weak flame
^ The control knob for the burner re-
quired must be pressed in and
turned anti-clockwise to the large
flame symbol to switch on.
^ When the flame ignites, keep the
control pressed in for 8-10 seconds,
and then let it go.
If the flame goes out, repeat the proce-
dure, keeping the control knob pressed
in for a few extra seconds.
16
^ When the flame burns steady after re-
^ Control the flame so that it does not
&
^ Turn the knob clockwise until the ß
This stops the flow of gas and the flame
goes out.
leasing the knob, select a setting be-
tween the large and the small flame
symbol. The flame gets smaller, when
you turn the control knob anti-clock-
wise and bigger when turning clock-
wise. You don't need to press the
knob.
spread out beyond the sides of the
pan. As the outer part of the flame is
much hotter than the centre, the tips
of the flames should stay beneath the
pan base. Flame tips which extend
beyond the sides of the pan merely
warm up the air in the room and can
also damage pan handles and in-
crease the danger of burning.
position is reached.
Remember: Turn anti-clockwise to
switch on, turn clockwise to switch
off. The control knob cannot be
turned anti-clockwise from the small
flame symbol to the ß position.